Atec Megger-MPRT8445 - Manual (Page 19)

Model Number MPRT
Preset Configuration
84 = Maximum Configuration of up to
8 Currents & 4 Voltage Outputs
Output Power Selection
Enter 15 = Lower Output 15 Amps / 150 Volts
per amplifier channel
Enter 30 = Higher Output 30 Amperes / 300
Volts per amplifier channel
Enter R = Rack-mount Option. Unit comes with
hardware for rack mount in 19 in rack
Enter L = Light weight enclosure with two side
carry handles
Enter H = Lightweight enclosure with two side
carry handles AND large handle
Amplifier Output Modules
Enter 1, 2, 3 or 4 for the number of customer
selected amplifier modules required
Enter 0 for no customer selected amplifier modules
T = Base Unit with Touch View Interface
F = Base Unit with Floating Outputs and TVI
Pre-Set Frequency Output Option
Enter 5 = Unit comes pre-set with output frequency of 50 Hz
Enter 6 = Unit comes pre-set with output frequency of 60 Hz
Power Cord Option
Enter A = North American Power Cord
Enter I = International Power Cord comes with jacket strip
international color coded wires ready for installation of desired
connector.
Enter E = Continental Europe Power Cord comes with CEE 7/7
Schuko plug.
Transit Case Options
Enter 0 = No carry case
Enter 1 = Soft-sided carry case
Enter 2 = Hard-sided transit case
Enter 3 = 2 Piece hard-sided transit case
ORDERING INFORMATION STYLE NUMBER IDENTIFICATION
8 4 T
*
MPRT
Megger Protective Relay Test System
19
*NOTE: If you order 3 (2 piece hard-sided transit case),
you must order L (the MPRT with the two side
carry handles only).