Atec Rohde-Schwarz-UPL - Manual (Page 11)

Audio Analyzer UPL 11
Results at a glance
• Real-time display of results for one
or both channels and several test
functions
• Simultaneous display of frequency
and phase
• With graphics, results can be read
off with vertical and horizontal cur-
sors. Tolerance curves or stored
results can be added for compari-
son
• Sets of traces can be displayed,
stored and evaluated for both
channels
• Graphics modes range from traces
and bargraphs through spectrum
display to three-dimensional water-
falls
It is often the case that only a few
parameters need to be modified after
a measurement sequence has been
started. Therefore, entry lines can be
selected from the input panels for the
generator, analyzer, etc, by marking
them with a tick. They are then trans-
ferred to a status panel. The status
panel thus gives a summary of param-
eters for a measurement routine,
which offers the following advan-
tages:
• Instrument settings can be displayed
together with graphical and numeri-
cal results
• All important information can be
printed on a single hardcopy
• Instrument settings can be modified
quickly without changing panels as
UPL can also be operated from the
status panel