Atec Agilent-N5181B-N5182B - Manual (Page 13)

13
Residual FM (CW mode, 300 Hz to 3 kHz BW, CCITT, rms)
5 MHz to 6 GHz < N x 2 Hz (measured) (see N value in frequency band table)
Harmonics (CW mode)
Range Standard < +4 dBm Option 1EA < +12 dBm
9 kHz to 3 GHz < –35 dBc < –30 dBc
> 3 to 4 GHz < –35 dBc, typical < –35 dBc, typical
> 4 to 6 GHz < –53 dBc, typical < –40 dBc, typical
Nonharmonics (CW mode) 1 () = typical
Range > 10 KHz offset
Standard (dBc) UNX or UNY (dBc)
9 kHz to < 5 MHz –65, nominal –65, nominal
5 to < 250MHz –75 –75 (–80)
250 to < 750 MHz –87 –96 (–100)
750 MHz to < 1 .5 GHz –87 –92 (–96)
1 .5 to < 3 .0 GHz –81 –86 (–90)
3 to 6 GHz –75 –80 (–84)
Subharmonics (CW mode) () = typical
9 kHz to 1 .5 GHz None
> 1 .5 to 3 GHz –77 dBc (–91)
> 3 to 6 GHz –74 dBc (–81)
Jitter (standard phase noise) 2
Carrier frequency SONET/SDH data rate rms jitter BW μUI rms, typical Seconds, typical
155 MHz 155 MB/s 100 Hz to 1 .5 MHz 91 .8 0 .6 ps
622 MHz 622 MB/s 1 KHz to 5 MHz 50 .5 81 fs
2 .488 GHz 2488 MB/s 5 kHz to 20 MHz 198 80 fs
Jitter (UNX or UNY phase noise) 2
Carrier frequency SONET/SDH data rate rms jitter BW
μUI rms,
measured
Seconds, measured
155 MHz 155 MB/s 100 Hz to 1 .5 MHz 40 0 .25 ps
622 MHz 622 MB/s 1 KHz to 5 MHz 21 33 fs
2 .488 GHz 2488 MB/s 5 kHz to 20 MHz 72 29 fs
Phase coherence (Option 012)
LO input frequency range 250 MHz to 6 GHz, nominal
LO input power range 0 to +12 dBm, nominal
LO output frequency range 250 MHz to 6 GHz, nominal
LO output power range 0 to +12 dBm, nominal
1. < 3 GHz fixed 100 MHz spur is specified @ –78 dBc. In signal-to-noise optimization mode 100 MHz spur is < –100 dBc, measured.
2. Calculated from phase noise performance in CW mode at +10 dBm. For other frequencies, data rates, or bandwidths, please consult your sales
representative.