Atec Anritsu_MT8801C - Manual (Page 9)

9
CDMA Measurement
CDMA Measurement (Option 12)
The Option 12 can measure the following systems;
USA 800-MHz cellular band (TIA/EIA/IS-95A stan-
dard), USA 1.9 GHz PCS band (ANSI J-STD-008 stan-
dard), Japan 800-MHz cellular band (ARIB STD-T53
standard).
The CDMA and analog dual mode standardized in the
IS-95A standard are supported.
CDMA Measurement Items
CDMA transmission measurement
Access probe output power
Stand-by power
Burst power
Burst power vs. time
Burst off power
Carrier on/off ratio
Carrier frequency, frequency error
Waveform quality, timing error
Modulation accuracy (vector error, phase error, ampli-
tude error, origin offset)
Open-loop power control time response
Occupied bandwidth
Spurious close to the carrier
Spurious
CDMA reception measurement
CDMA signal generator
Frame error ratio
AWGN generator
Analog transmission/reception measurement
Audio oscillator
Noise generator
Modulation analysis (modulation factor, distortion)
Frequency counter
FM signal generator
Call processing function
Registration
Call origination
Call termination
Conversation
Loopback
Frequency channel switching (IS-95A standard: dual
mode)
Disconnection from mobile station and network
Waveform quality measurement
Gated output power measurement
Frame error rate measurement