Atec Anritsu_MT8801C - Manual (Page 6)

6
Transmission Measurement
Characteristics such as frequency, power, and fre-
quency deviation can be measured easily.
AF Low Impedance Output (Option 04)
This option converts the output impedance of the AF
oscillator of the Option 01 Analog Measurement to
low impedance. It permits direct driving of an external
speaker connected to the AF output connector.
Reception Measurement
An FM modulated signal is output to permit measure-
ment of the frequency and level of the AF signal from
a receiver, as well as SINAD and distortion.
AF Measurement
An AF signal is output to measure the frequency, level
and distortion of the AF signal at the DUT.
Analog Measurement
Analog Measurement Function (Option 01)
The MT8801C has general analog measurement func-
tions too. Efficient FM TX/RX testing is made easy by
built-in signal generator, AF oscillator, RF analyzer
(power meter, frequency counter, FM measurement)
and audio analyzer functions. This function is espe-
cially useful for the IS-136A analog test.
Transmission Measurement with SG Function
Transmission characteristics can be measured by out-
putting an FM RF signal from the built-in signal gener-
ator.