beautypg.com

Battery maintenance guidelines, Recycling and disposal instructions – Alpha Technologies UPE-6 User Manual

Page 6

background image

6

031-124-C0-004, Rev. D

Safety Notes

Review the drawings and illustrations contained in this manual before proceeding. If there are any questions
regarding the safe installation or operation of this product, contact Alpha Technologies or the nearest Alpha
representative. Save this document for future reference.

To reduce the risk of injury or death, and to ensure the continued safe operation of this product, the following
symbols have been placed throughout this manual. Where these symbols appear, use extra care and
attention.

The use of ATTENTION indicates specifi c regulatory/code requirements that may affect the placement of
equipment and /or installation procedures.

ATTENTION:

A NOTE provide additional information to help complete a specifi c task or procedure.

NOTE:

The use of CAUTION indicates safety information intended to PREVENT DAMAGE to material or equipment.

CAUTION!

WARNING presents safety information to PREVENT INJURY OR DEATH to the technician or user.

WARNING!

Battery Maintenance Guidelines

The battery maintenance instructions listed below are for reference only. Battery manufacturer’s instructions for
transportation, installation, storage or maintenance take precedence over these instructions.

To prevent damage, inspect batteries every 3 months for:

Signs of battery cracking, leaking or swelling. The battery should be replaced immediately by authorized
personnel using a battery of the identical type and rating.

Signs of battery cable damage. Battery cable should be replaced immediately by Authorized Personnel using
replacement parts specifi ed by vendor.

Loose battery connection hardware. Refer to battery manufacturer’s documentation for the correct torque and
connection hardware for the application.

Apply battery manufacturer’s specifi ed antioxidant compound on all exposed connections.

Verify battery terminals and/or exposed connection hardware is not within 2 inches of a conductive surface.
Reposition batteries as necessary to maintain adequate clearance.

Clean up any electrolyte (battery emission) in accordance with all federal, state, and local regulations or codes.

Proper venting of the enclosure is recommended. Follow the Battery Manufacturer’s approved transportation and
storage instructions.

Always replace batteries with those of an identical type and rating. Never install old or untested batteries.

Do not charge batteries in a sealed container. Each individual battery should have at least 0.5 inches of space
between it and all surrounding surfaces to allow for convection cooling.

All battery compartments must have adequate ventilation to prevent an accumulation of potentially dangerous gas.

Recycling and Disposal Instructions

Spent or damaged batteries are considered environmentally unsafe. Always recycle used batteries or dispose of the
batteries in accordance with all federal, state and local regulations.

This manual is related to the following products: