Important safety messages, Notice – Franklin Fueling Systems TS-ROM2 User Manual

Page 3

Important Safety Messages

INCON equipment is designed to be installed in association with volatile hydrocarbon liquids such as gasoline and diesel

fuel. Installing or working on this equipment means working in an environment in which these highly flammable liquids may

be present. Working in such a hazardous environment presents a risk of severe injury or death if these instructions and

standard industry practices are not followed. Read and follow all instructions thoroughly before installing or working on this,

or any other related, equipment.
As you read this guide, please be aware of the following symbols and their meanings.

This symbol identifies a warning. A warning sign will appear in the text of this document when a potentially

hazardous situation may arise if the instructions that follow are not adhered to closely. A potentially hazardous

situation may involve the possibility of severe bodily harm or even death.
This is a caution symbol. A caution sign will appear in the text of this document when a potentially hazardous

environmental situation may arise if the instructions that follow are not adhered to closely. A potentially

hazardous environmental situation may involve the leakage of fuel from equipment that could severely harm

the environment.

Warning

Caution

Warning

Follow all applicable codes governing the installation and servicing of this product and the entire

system. Always lock out and tag electrical circuit breakers while installing or servicing this

equipment and any related equipment. A potentially lethal electrical shock hazard and the possibility

of an explosion or fire from a spark can result if the electrical circuit breakers are accidentally

powered on during installation or servicing. Please refer to the Installation and Owner’s Manual for

this equipment and the appropriate documentation for any other related equipment, for complete

installation and safety information.
Follow all federal, state and local laws governing the installation of this product and its associated

systems. When no other regulations apply, follow NFPA codes 30, 30A and 70 from the National Fire

Protection Association. Failure to follow these codes could result in severe injury, death, serious

property damage and/or environmental contamination.
Always secure the work area from moving vehicles. The equipment in this manual is usually mounted

underground, so reduced visibility puts service personnel working on this equipment in danger from

moving vehicles entering the work area. To help eliminate these unsafe conditions, secure the area

by using a service truck to block access to the work environment, or by using any other reasonable

means available to ensure the safety of service personnel.
All wiring must enter the Tank Sentinel

enclosure through the non-intrinsically safe knockouts as

shown in Figure 1. An explosion hazard may result if other openings are used.
Refer to console installation and wiring as described in the Tank Sentinel

Installation Guide

(P/N 000-1050), and the programming instructions as described in the Tank Sentinel

Setup

Programming Guide (P/N 000-1053). Read and understand all manuals, including this one, before

proceeding with installation. The recommended hardware and information presented in this guide

is particular to the TS-ROM2 (Relay Output Module). Any other required hardware not listed here is

listed in the TS-1000 Installation Guide.

Warning

3 of 8

INCON is a wholly owned subsidiary of Franklin Fueling Systems.

Notice

INCON reserves the right to change this document and specifications at any time without notice. INCON makes no

expressed or implied warranty with regard to the contents of this manual. INCON assumes no liability for errors or

omissions, or for any damages, direct or consequential, that result from the use of this document or the equipment that it

describes.

Warning