NXG Technology NX-RM610 - Manual (Page 38)

1 From the RF Settings Menu, select BLAST.
2 Decide whether you are changing the Blaster for all devices or just
one of the devices of the NX-RM610.
Select ALL to change the blaster
settings to ALL devices in the NX-
RM610. Then, go to Step 4.
Select DEVIC to change the blaster
settings to just one of the devices in
the NX-RM610. Then, go to Step 3.
3 The display changes to a list of the names of your devices. If you
have two pages of devices, pressing either of the page buttons will
display the other page. Select the device you would like to change
IR/RF settings, then go to Step 4.
4 Select the new setting by pressing the desired button, then press
SAVE to save your new setting and return to the RF settings menu.
NX-RM610
36
Exit this Menu
without changing
the EMITT settings
Save the new setting
Changes the
current front panel
BLASTER setting
Page Button
displays the
other page
of devices.
Select a
device
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 38