NXG Technology NX-RM610 User Manual
Page 13
7
Press and hold the button you want on your old remote control
until the display changes to either “GOOD” or “FAILED”.
If the “GOOD” label appears on top of the display, you were
successful. Now, press the next button you wish to teach. Keep
repeating steps 6 through 7 until you have learned all the buttons
you want.
If the “FAILED” label appears on top of the display, try to teach the
same button in NX-RM610 once again by repeating steps 6-7.
8
Continue to teach any commands from any of your remote controls
by repeating steps 5-7 (to go back to step five, press MAIN once).
9
Once you completed teaching all the buttons, return to normal
operation by pressing the MAIN button twice. Test all your new
commands. If any of them don’t work, try learning again using
these notes:
Move to another room. Plasma TVs, sunlight, halogen or quartz
lighting can interfere with the learning process.
Although the old remote control seems to work fine, change the
batteries to fresh alkaline batteries.
Vary the distance between the remote controls gradually. Try
1/4”, 1”, 2”and so on, up to 4 feet.
Tap the button on the original remote control instead of pressing
and holding it during the learning process.
NX-RM610
11
NX-RM610_Remote_Manual 10/6/08 4:04 PM Page 13