Learning method – NXG Technology NX-RM610 User Manual
Page 11
9
Repeat steps one through nine for each of your devices. Test all the
commands you’ve programmed. If you are missing any commands,
use the learning method, described next:
Learning Method
The NX-RM610 can learn commands from your old remote controls
one-button-at-a-time on any button of any device, on the MAIN or
FAV LCD buttons or on the MAIN hard buttons, by following these
simple steps:
1
Line-up the NX-RM610 with your old remote control,
head-to-head, one or two inches apart.
2
On the NX-RM610, press and hold the MAIN and ENT (Enter) buttons
at the same time for approximately three seconds. The top of the
display will show “SETUP”. You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in
SETUP mode. If you don’t press a button within that time, the
NX-RM610 will time out and return to normal operation.
3
Press the LEARN button.
The top of the screen will change to “LEARN”.
NX-RM610
9
LEARN
Button
NX-RM610_Remote_Manual 10/6/08 4:04 PM Page 11