NXG Technology NX-RM610 - Manual (Page 27)

25 Erasing
You can erase an individual button with a learned command, a
macro or a favorite channel. You can erase an entire Device’s
learned command or macro buttons. You can also erase ALL your
learned commands on all devices or all your macros or favorite
channels everywhere. If you really want a fresh start, it is possible
to reset everything to the factory default condition.
Erasing Learned Buttons, Macros or Favs
1 Enter SETUP mode by pressing and holding both MAIN and ENT for
three seconds.
Note: You have 30 seconds for each step, otherwise the NX-
RM610 will time out automatically.
2 Press the ERASE button.
3 Press either the LEARN, MACRO or FAV button.
The following screen appears:
ALL — If you press ALL, the NX-RM610 displays a SURE? button.
After the SURE button is pressed, all the buttons will be erased.
DEVICE — If you press DEVICE, a list of Devices will appear. Press the
device button that you wish to erase. The bottom of the screen
will flash ERASE twice, then ERASED.
KEY — If you press KEY, you’ll have to navigate to the Device and Page
you want using the MAIN, DEVICE and PAGE buttons. Press a
button to erase it. The bottom of the display will flash ERASE
twice, then ERASED.
4 To return to normal operating mode, press the MAIN button four
times.
NX-RM610
25
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 27