NXG Technology NX-RM610 - Manual (Page 14)

Volume Control Punch Through
In most home entertainment systems, the sound volume is only
controlled by one device. In some systems, it is the TV speakers
that make the sound, so you would use the TV device on the
NX-RM610 to raise and lower the volume. In another system, it
might be a surround sound receiver and speakers that control the
sound, so you would use the N-RM610’s AUDIO device to adjust
the volume. Constantly switching the N-RM610 to TV or AUDIO
to adjust the volume is inconvenient in daily life.
You can use Punch Through to set the NX-RM610’s volume buttons
to always control the sound in your system. That way when the
NX-RM610 is set to VCR or DVD, the volume up, down and mute
buttons will work perfectly without switching back to AUDIO or TV.
Here’s how:
1 Enter Setup mode by pressing and holding both MAIN and ENT for
three seconds. The top of the display show you are in SETUP mode
now.
Note: You have 30 seconds for each step, otherwise the
NX-RM610 will time out automatically.
2 Press the PUNCH button.
3 Press the VOL button. The display confirms by displaying “VOL” at
the top of the screen. This sets up the group of three buttons
(Volume Up, Volume Down and Mute) in one action!
The bottom of the display flashes “PUNCH TO”
NX-RM610
12
Select the
Transport group
(Play, Pause,
Stop, Rew,
FFwd)
Select the MENU
group (Menu,
Guide, Info, Exit,
Up, Down, Left,
Right, Sel)
Select the VOL-
UME group (Vol
Up, Down &
Mute)
Select the
POWER group
(ON and OFF)
Select the
CHANNEL group
(Channel Up,
Channel Down
and PREVCH)
NX-RM610_Remote_Manual 10/6/08 4:04 PM Page 14