NXG Technology NX-RM610 - Manual (Page 35)

33 ID # - Setting Base Station Address
When you are installing a system within 100 feet of another equip-
ment location in the same home OR near a home, condo, yacht or
motor home that might potentially have an RF remote control of
any kind, it is recommended that you use an addressable base sta-
tion and set the address as described here.
You can operate up to 15 different equipment locations, each with
an NX-RF200 assigned a unique Receiver ID#. You program each or
all of your NX-RM610 devices to the appropriate equipment loca-
tion by assigning the corresponding ID# in the RF Settings Menus.
1 From the RF Settings Menu, select ID#.
2 Decide whether you are changing the ID# for all devices or just one
of the devices of the NX-RM610.
Select ALL to change the ID# for ALL
devices in the NX-RM610. Then, go
to Step 4.
Select DEVIC to change the ID# for
just one of the devices in the NX-
RM610. Then, go to Step 3.
3 The display changes to a list of the names of your devices. If you
have two pages of devices, pressing either of the page buttons will
display the other page. Select the device you would like to change
the ID#, then go to Step 4.
NX-RM610
33
Select a
device
Page Button
displays the
other page
of devices
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 35