NXG Technology NX-RM610 - Manual (Page 36)

4 Select the new setting by pressing the desired button, then press
SAVE to save your new setting and return to the RF settings menu.
EMITT - Setting IR Emitter Outputs
The NX-RF200 Base Stations enable you to route or steer the IR
commands from any Device to any or all of the IR Line Outputs.
This allows you to control identical devices using the exact same IR
commands (such as an array of television sets in a media room or
a stack of identical satellite receivers installed in a central location
with one satellite receiver dedicated to each room with a television).
Each button push (or macro step) is routed to the specific IR Line
Output you’ve assigned to a device. In the factory set default set-
tings, the NX-RM610 is set to route IR commands from any device
to ALL IR Line Outputs simultaneously. To change the NX-RM610
default settings follow these steps:
1 From the RF Settings Menu, select EMITT.
2 Decide whether you are changing the Emitter settings for all devices
or just one of the devices of the NX-RM610.
Select ALL to change the Emitter
settings to ALL devices in the
NX-RM610. Then, go to Step 4.
Select DEVIC to change the Emitter
settings to just one of the devices in
the NX-RM610. Then, go to Step 3.
NX-RM610
34
Change ID#
using UP and
DOWN buttons
Displays the
current ID#
Save the
new setting
Exit this
Menu without
changing the
IR/RF settings
NX-RM610_Remote_Manual 10/6/08 4:05 PM Page 36