NXG Technology NX-RM610 - Manual (Page 21)

19 Macro Button Setup
Imagine turning on your TV, your DVD player and your surround
sound receiver by pressing a single button on your NX-RM610!
What would normally take three remotes and pushing three but-
tons, the NX-RM610 can accomplish with the press of one button.
We call that a “Macro”. Any of the Display buttons, the Power On or
the Power Off buttons (on any Device or Page) can be set to be
Macro buttons!
To setup a macro button, follow these easy steps:
1 Enter the SET UP mode by pressing and holding both MAIN and ENT
for three seconds.
Note: You have 30 seconds for each step, otherwise the NX-RM610 will
time out automatically.
2 Press the MACRO button. The top of the display will show “MACRO”.
The bottom of the display will flash “SELECT”.
3 Navigate to the Device and Page where there is a button you would
like to set as a Macro button using the MAIN, DEVICE, and PAGE
buttons.
Advanced Options:
If you wish to set one of the DEVICE buttons as a macro, on step 3, tap the Page
button until the top of the display changes to MAIN. Using the PAGE button you
can navigate to MAIN page 1 or page 2 before going on to Step 4.
Another option for DEVICE button macros is to only send the macro if the button
is pressed and held. This is setup by entering a delay as the first step of the
macro.
The amount of delay determines how long the user must press the button before
the macro is sent. The advantage of this option is that a normal press of the
DEVICE button will simply switch devices without issuing the macro.
4 Press the button you want to set as a Macro button. The top of the
screen will display the label of the button you selected. At the bottom
of the screen it displays”STEP0”, indicating that no macro steps have
been entered yet.
5 Navigate to the Device and Page that has a button you want in your
NX-RM610
19
NX-RM610_Remote_Manual 10/6/08 4:04 PM Page 21