Extron Electronics SW HDMI LC User Guide - Manual (Page 33)

SW HDMI LC • Reference Information 27
4. Mount the switcher to the rack support, using the two included rack screws.
MA V SERIES AV MA TRIX SWITCHER I/O
AUD
AUDI O SETUP
PRESE T
VID
IR
+dB
-dB
EN TER
2
7
6
5
2
4
1
INPUTS
OUTPUTS
8
3
1
8
6
5
4
3
7
Figure 21. Mounting an SW HDMI LC Switcher to a Back of the Rack Support
Furniture Mounting
To mount an SW HDMI LC switcher under a desk, table, or podium, use the optional
MBU 123 Mini Under-Desk Mounting Kit (part #70-212-01) as follows:
1. If rubber feet were previously attached to the bottom of the unit, remove them.
2. Remove the two screws from each side of the switcher. Retain the screws for possible
later reassembly.
3. Attach the brackets to the sides of the unit, using the provided machine screws.
Figure 22. Preparing the SW HDMI LC Switcher for Under-desk Mounting
4. Hold the unit with the attached brackets against the underside of the table or other
furniture. On the mounting surface, mark the location of the bracket screw holes.
5. Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.