Command/response table for sis commands, Command/response table for sis commands . 15, Front panel ir receiver disable – Extron Electronics SW HDMI LC User Guide User Manual
Page 21: In the command/r
SW HDMI LC • Remote Communication and Control
15
Command
ASCII Command
(host to unit)
Response
(unit to host)
Additional Description
Input selection
Select input
X!
!
In
X!
• All
]
Select input
X!
.
X!
= input number 0 through highest number
of inputs on the switcher. For
X!
:
0 = deselect all inputs
Input equalization
Adjust EQ level for an individual
input
E
X!
*
X@
ISEQ
}
X!
ISEQ •
X@
]
Adjust the equalization level for input
X!
to
X@
.
For
X@
:
0 = low (6 dB)
1 = high (18 dB)
Adjust EQ level for all inputs
E
X@
ISEQ
}
ISEQ •
X@
]
Adjust the equalization level for all inputs to
X@
.
View EQ status
E
ISEQ
}
ISEQ •
X@
• ...
X@
]
View the current equalization level
X@
for all
inputs.
Video muting
Video mute
X@
B
Vmt
X@
]
Mute the video signal. For
X@
:
0 = unmute
1 = mute
Query video mute
B
X@
]
Show video muting status
X@
.
Signal status
Request all signal status
0LS
Sig
X#
...
X#
]
Show the signal status
X#
for all inputs. For
X#
:
0 = no signal detected
1 = source signal detected (+5 V)
2 = signal detected (TMDS clock)
Front panel lockout
Enable/disable executive mode
X@
X
Exe
X@
]
Lock or unlock the front panel controls. For
X@
:
1 = Lock the front panel.
0 = Unlock the front panel (default).
View lockout status
X
X@
]
Show executive mode On or Off status.
Front panel IR receiver disable
Enable and disable IR receiver
X@
* 65#
IRDisable
X@
]
Enable or disable the IR remote receiver on the
front panel from receiving signals from the IR
remote control. For
X@
:
0 = Set the IR Disable feature to Off (IR is
enabled [default].)
1 = Set the IR Disable feature to On (IR is
disabled).
View IR status
65#
X@
]
View the IR receiver lock status.
Request information, part number, and firmware version
Request information
I
V
X!
• F
X$
• Vmt
X@
]
Show the selected input, switch mode, and
video muting status.
X!
= input number: 1 through highest number
of inputs available. 0 = all inputs muted.
X@
= muting status:
0 = unmuted
1 = muted
X$
= switch mode:
1 = normal switch mode
2 = auto-input switch mode
Example:
I
V4 F2 Vmt0
]
On an SW4 HDMI LC, input 4 is selected, auto-
input switch mode is enabled, and the video is
not muted.
Command/response Table for SIS Commands