Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 50)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-18
Example 3: Removing a tie from a set of ties
In the following example, an existing audio tie is removed from the current
configuration. The steps show the front panel indications that result from your
actions.
N This example assumes that you have performed example 1 and example 2.
1 . Clear all selections : Press and release the Esc button.
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
2 . Select audio only for the tie : If necessary, press and release the RGBHV
(CrossPoint 450 Plus switchers) or Video (MAV Plus video switchers) button
and the Audio button.
I / O
RGBHV AUDIO
Press the RGBHV or Video button to toggle on and off.
The button is unlit or background illuminated
when deselected.
Press the Audio button to toggle on and off.
The button lights
red when selected.
3 . Select an input : Press and release the input 5 button.
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
O
U
T
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9 I
N
P
U
T
S I
N
Press and release the Input 5 button.
The button lights
red to indicate that audio
outputs can be tied to or untied from this input.
The Output 3, Output 4, and Output 8 buttons light red to
indicate the audio ties created in example 1.
The output 1 button does not light to indicate the tie created
in example 2 because that tie is RGBHV or video only.
3 . Select the output : Press and release the output 4 button.
C O N T R O L
PRESET ENTER ESC VIEW
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
25
9
O
U
T
Press and release the Output 4 button.
The button blinks
red to indicate the pending change: audio input will be untied.
The Enter button blinks
to indicate the need to
confirm the change.