Preferences menu, Preferences.menu -22, Matrix software, cont’d – Extron Electronics MAV Plus series Large Scale User Guide User Manual
Page 134

Matrix Software, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software
5-22
Preferences menu
Immediate Changes
—
Causes configuration changes to take
effect immediately.
Hold/Verify Changes
—
Delays implementation of
configuration changes until the Changes – Take button
is pressed.
Ties as Lines
—
Displays ties as lines (below).
Ties as Crosspoints
—
Displays ties as a matrix of inputs and outputs (figure 5-17).
Ties that have been made are indicated as amber or green boxes. Ties that
will take effect when you click the Take button are indicated by +. Ties that
will be broken when you click the Take button are indicated by –.
Figure 5-17 — Ties shown as crosspoints
Frequency-read options
(CrossPoint only) — Allows you to set the input signal
detection (DSVP) feature as follows:
• To never sample and display the sync or no sync status
(select None)
• To automatically refresh the display
(select Automatically every 10 seconds)
• To sample the sync and update the display whenever you make a
configuration change (select On demand or by refresh).
Limit ties to same group
—
Allows you to limit the creation of ties using the
program to inputs and outputs that are in the same group (similar to front
panel operation).