beautypg.com

Using the switch and button table, Switch number locations, Using the switch and button – Extron Electronics SCP 104 Series User Guide User Manual

Page 46: Table

background image

Using the Switch and Button Table

Switches are assigned to specific buttons on the SCP, any
attached remote control module (IRCM or RCM), or the IR 402
remote. Each time a button is pressed or released, or a knob
is turned on the SCP or a control module, the switch number
associated with that button appears on the screen of your PC
terminal emulator (for example, HyperTerminal or DataViewer)
as part of the host response.
On most of the special function SIS commands, the switch
number is the value that you enter as part of the command
(see ”

Command and Response Table for Special Function SIS

Commands

” on page 38).

The

Switch and Button table

on page 44 shows which switch

number is associated with each button or knob on the SCP,
control module, or IR 402. In the Switch column, locate the
switch number displayed on your terminal emulator, then look
in the Button column beside the number to find out which
button was pressed or released.

NOTES:

The SCP does not use all of the available buttons

and switches.

No buttons can be programmed via the SCP.

Switch Number Locations

Figures

35

and

36

on the next page and figure

37

on page 42

show the button and switch memory block numbering on the
SCP front panels and on the IR 402 remote control (see the

Switch and Button table

). The switch locations are the same on

the SCP 104/226 AAP and on the SCP 226 L.

40

SCP 104 and SCP 226 • Remote Communication

This manual is related to the following products: