Extron Electronics SCP 104 Series User Guide - Manual (Page 35)

8. Start the Firmware Loader program by clicking the
Firmware Loader icon on your computer
Start
menu. The Firmware Loader Add Device screen
appears.
Figure 31. Firmware Loader Add Device Screen
9. From the four drop-down menus, select the following:
• Device Name : SCP 104 or SCP 226
• Connection Method : RS-232
• Com Port : Select the Com port through which your SCP
will communicate with your PC via RS-232.
• Baud Rate : 9600
10. Click Connect . When the computer connects to the SCP, the
following message appears in the Connected Device field:
Figure 32. Successful Connection Message
11. In the New Firmware File (Optional) section of the Add
Device screen, click Browse .
SCP 104 and SCP 226 • Installation and Operation 29