Extron Electronics SCP 104 Series User Guide - Manual (Page 25)

Mounting the SCP
After the system has been cabled and tested, the control panel
can be mounted to the wall or furniture.
Mounting Options
You can mount the SCP 104/226 in an electrical box or surface
mounting box (not provided), or you can use a mounting
bracket (not provided) to secure it to a wall, podium, table, or
other furniture. Extron offers a variety of mounting boxes and
brackets that you can purchase for the different SCP 104/226
models.
In-wall or in-furniture mounting options
To mount the SCP 104/226 in areas of walls or furniture
without studs, use an optional mounting bracket. These
Extron mounting brackets (also called “mud-rings”) can be
ordered separately (see "
Accessories " on page 46 for their part
numbers).
External mounting options
To mount the SCP 104/226 externally on a wall or furniture,
you can use one of the following Extron mounting options,
or obtain an equivalent mounting option locally. Follow
the directions provided with the mounting option. See the
"
Accessories " table for part numbers for these options.
• External Wall Box (EWB) series
• Surface Mounting Box (SMB)
• Universal Controller Mount (UCM)
• MediaLink Mounting Wall Box (MLM-WB+)
Mounting to an Electrical Box
Follow these steps to mount an SCP 104/226 or an
SCP 104/226 AAP in a UL approved electrical junction box.
1. Mount the junction box in the desired mounting surface,
following the instructions provided with the box.
2. If you are installing an SCP AAP model, attach any
architectural adapter plates (AAPs) that you want to install
in the AAP frame of the SCP.
3. Connect power to the SCP.
4. Insert the SCP into the mounted electrical box.
5. Secure the SCP to the box with the provided machine screws.
Figure 18 on the next page shows an SCP 104 mounted in a
two-gang electrical box.
SCP 104 and SCP 226 • Installation and Operation 19