Connections, controls, and indications – Extron Electronics PowerCage FOX SR HDMI User Guide User Manual
Page 11
PowerCage FOX SR HDMI Scaling Receiver • Installation and Operation
5
Connections, Controls, and Indications
a
Fiber optic connectors and LEDs —
WARNING: Risk of eye injury: The receiver outputs
continuous invisible light, which may be
harmful to the eyes; use with caution.
•
Do not look into the rear panel fiber optic
cable connectors or into the fiber optic
cables while the receiver is powered on.
•
Plug the attached dust caps into the
optical transceivers when the fiber cable is
unplugged.
NOTE: Connect a transmitter to one or more receivers:
•
One-way (transmitter Tx to receiver Rx)
only — Connect fiber cable
Ä
from the
transmitter Tx connector
only.
•
Two-way (transmitter to receiver and
return) — Connect fiber cber cable
Å
back to
the transmitter Rx connector (see figure
3).
•
One-way (transmitter to receiver) with
daisy chain (receiver to receiver) —
Connect fiber cable
Ä
from a fiber optic source
and cable
Å
to the next receiver in the daisy
chain (see figure
4). Set each receiver in the
daisy chain to daisy chain mode. Up table
Ä
from the transmitter Tx connector and fio 10
properly-configured receivers can be connected
in a daisy chain to a single transmitter.
From Transmitter
or Daisy-Chained
Receiver
Receiver
Receiver
1b
1a
1a
Tx
Rx
Tx
Rx
Figure 4.
Daisy Chain Configuration
NOTES: • Ensure that you use the proper fiber cable for your transmitter/receiver
pair. Typically, singlemode fiber has a yellow jacket and multimode cable
has an orange or aqua jacket.
• Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for
video, audio, and serial command transmission. However, if you connect
only one fiber optic cable, or if your receiver is configured to daisy-chain
the optical signal:
•
The HDMI signal output by the receiver
is not HDCP-compliant.
•
You
will not receive RS-232 reports from the controlled device.
To receive responses from the controlled device and for HDCP
compliance, you need to install both fiber optic cables and leave link 2
enabled via an
[see page 18] or using the
Processing Product Control Program
[see page 24]).
1 2
REMOTE RS-232
RS-232
OVER FIBER
Tx
ALARM
Rx
OUTPUT
PowerCage
FOX SR HDMI
Tx Rx
G
Tx Rx
G
LR
AUDIO
VIDEO
HDCP
ON
HDMI
AUDIO
OFF
AUDIO
1
8
2
3
4
6
7
9
5
Figure 2.
Connectors,
Controls, and
Indications
Figure 3.
Two Way
Configuration
Transmitter
Receiver
1b
1a
1a
1b
Tx
Rx
Tx
Rx