Extron Electronics MLM-WB+ - Manual (Page 24)

MLM-WB+ • Installation 18
• Using mounting screws to secure each piece of equipment with rack mounting
ears to the holes in the enclosure
SYST EM 5 IP
PC VID EO INP UT 5
CL IP NO RM AL VO LU ME AU DIO
AD JU ST
SIG NA L
DIS PL AY RO OM CO NT RO L
INP UT SE LE CT ION
SWSTEM SWITCHER
CO NFIG IR
ME NU NEX T
2 3 4 5/ R GB
1
LAP TOP DVD VCR
DESKT OP PC 1
RO OM REL AY 3 RO OM REL AY 2 RO OM REL AY 1 OFF ON
PR OJ EC TOR 1 2 3
4 5 6
VO LU ME CO NFI G IR
PC
AUX VID EO DV D VCR
LAP TOP
AU TO IMA GE
MUT E ON OFF
Ext ron
ML C 2 26 I P L
Figure 16. Securing Equipment with Rack Mounting Brackets (Rack
Ears)
NOTE: Do not tighten the clamps or screws completely until you have tested
the installation and made any needed adjustments to the cabling or switch
settings.
7. Replace the top of the enclosure and use the four screws you removed in
step 1 to reattach it.
Testing the Installation
Test the installation as follows:
1. Supply power to all input and output devices, the host computer, and so on.
2. Test all equipment, connections, and devices. Make adjustments to wiring, switch
settings, and so on, as needed.
Completing the Installation
After you have pretested the installation and made any necessary adjustments, you can
secure all equipment in the MLM-WB+.
1. Secure the equipment in the 4U rack enclosure by completely tightening the clamps
or rack mounting screws.
2. Using cable ties, secure all power and AV cables to the cable guide behind the 4U
rack enclosure (cut off any excess cable tie that protrudes). This provides strain
relief as you open and close the door.