Extron Electronics MLM-WB+ - Manual (Page 20)

MLM-WB+ • Installation 14
Installing AV and Control Cables
This section explains how to route AV and control cables through the MLM-WB+.
NOTE: To reduce electromagnetic interference, route the AV and control cables
separately from the power cables.
1. Remove the right, left, or both side panels from the MLM-WB+ by loosening the nuts
on the inside of the unit and then pushing the panels out. Set the panels aside.
Loosen nut
to remove
side panel.
Figure 11. Removing the MLM-WB+ Side Panels
2. Feed the AV cables through the small rectangular openings in the right side panel to
route cables to and from the 4U and 2U rack enclosures.
3. Route the AV and control cables through the opening in the rear panel or through the
top or bottom of the enclosure through the knockout.
If you route cables through the top or bottom of the MLM-WB+, install a conduit or
raceway through a knockout. Allow enough cable inside the MLM-WB+ to permit the
door to open fully when cabled equipment is installed.
NOTE: The installer is responsible for providing the conduit and fittings; Extron
does not provide these items.