Extron Electronics MTP R 15HD RSA D User Guide - Manual (Page 20)

MTP R 15HD RSA D • Reference Information
Reference Information
16
Specifications
Video
Gain ................................................. Unity
Number/signal type ..................... 1 set of proprietary analog signals
Connectors ..................................... 1 female RJ-45 on a pigtail
Video input — See MTP Series Transmitters' video
output specifications.
Video output
Number/signal type ..................... 1 analog VGA-UXGA RGBHV, RGBS,
RGsB, RsGsBs, HD component video,
component video, S-video, or composite
video
Connectors ..................................... 1 female 15-pin HD
Nominal level ................................ 1 Vp-p for Y of component video and
S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of
component video
0.3 Vp-p for C of S-video
Minimum/maximum levels ........ 0.3 V to 1.45 Vp-p
Impedance ...................................... 75 ohms
Return loss ...................................... <-30 dB @ 5 MHz
DC offset ......................................... <±20 mV with input at 0 offset
Maximum resolution .................... 2048 x 1080
Sync
Output type .................................... RGBHV, RGBS, RGsB, RsGsBs
Standards ........................................ NTSC 3.58, NTSC 4.43, PAL, SECAM
Output level ................................... 4.0 V to 5.0 Vp-p, unterminated
Output impedance ........................ 110 ohms
Polarity............................................ Positive or negative (switch selectable)
Audio
Number/signal type ..................... 1 set of proprietary analog signals from an
MTP transmitter
Connector ....................................... 1 female RJ-45
Gain ................................................. Unbalanced output: 0 dB;
balanced output: +6 dB
Frequency response ...................... 20 Hz to 20 kHz, ±1 dB