Extron Electronics MS9400 HD FrEND - Manual (Page 50)

MS9400 HD FrEND User Guide Appendix D: Specifications
50 Rev. 1.54
Appendix A:
TCP/IP Communications
An Introductory Note
A full explanation of Ethernet communication is beyond the scope of this user guide. However, the following
details should provide enough information to understand the basic concepts.
Ethernet Communication
The MS9400 HD FrEND can be controlled via RS-232 and Ethernet connections. Most users will be familiar
with RS-232 communication. Ethernet communication, while not a new development, is still a mystery to many.
Let’s compare the differences between RS-232 and Ethernet data:
RS-232
ƒ Designed for one port to connect to one device
ƒ Messages transmitted as a whole
ƒ No way to guarantee receipt of data
ƒ Maximum data transfer speeds of around 115 Kbps
Ethernet
ƒ Designed to connect many devices (called a “network”) on a single port
ƒ Messages transmitted in “packets”, as network traffic allows
ƒ Each device in the network has a unique address, ensuring that a data message goes only to the specified
device
ƒ Maximum data transfer speeds greater than 100 Mbps
Several types of Ethernet communications exist. The protocol, or language, that the MS9400 uses for its Ethernet
communication is called TCP/IP (Transmission Control Protocol and Internet Protocol).
TCP/IP Addressing
Each device on a network requires a unique address to ensure that data is sent only to the device it is intended to
reach. Two methods exist for assigning an Ethernet addresses in a TCP/IP network:
1. Dynamic assignment
2. Static assignment