beautypg.com

Extron Electronics MS9400 HD FrEND User Manual

Page 18

background image

MS9400 HD FrEND User Guide

Chapter 2: Player Controls and Set-Up

18 Rev.

1.54

Configuration

Assuming correct connection of the MS9400 into a display system, perform system steps 1-3 below (same as in
“Quick-Start”) to turn on the player and access the configuration menus:

1. Turn on the main POWER OFF/ON switch at the rear of the player (the power LED on the front panel

will glow). NOTE: Should the power Led not illuminate, toggle the power switch between OFF/ON.

2. The Hard Drive Led will flash whilst the MS9400 is completing its initialization. This could take up to 30

seconds. Once the hard drive Led has stopped flashing the unit is ready for configuration.

3. Press the

button on the remote control (having first, pressed the button). The on-screen

menu appears:

The up-coming sections give information on how to the edit the configuration settings within the MENU.

NOTE: You may wish to press the button on your Remote Control to display:

ƒ System Info: Disk Capacity and Disk space in use

Or, Select a File (.mpg) and press the ‘Info’ button on the Screen-Menu to display:

ƒ System Info: Disk Capacity, Disk space in use.

ƒ File Info: File name and PID information.

Check this data before file transfer to avoid exceeding the Hard Disk capacity.

NOTE: The HD FrEND Serial and Software Version Numbers are displayed at the top of the System Display.

Refer to the section ‘System’ later in this Chapter.