Extron Electronics MS9400 HD FrEND User Manual

Page 14

MS9400 HD FrEND User Guide

Chapter 2: Player Controls and Set-Up

14 Rev.

1.54

“Quick Start”

Assuming correct connection of the MS9400 into a display system, perform system steps 1-3 below to turn on the
player:

1. Turn ‘on’ the main POWER OFF/ON switch at the rear of the player (the power LED on the front panel

will glow). NOTE: Should the power Led not illuminate, verify that the power supply is securely
connected then toggle the power switch between OFF/ON.

2. The Hard Drive Led will flash during initialization (this could take up to 1 minute).

3. Once initialization is finished, a pre-loaded file will begin playing. Video will appear on the display and

audio will be heard from the speakers - this confirms the correct system ‘hook-up’. Default play mode is
‘Loop Play’; the file will continue playing repeatedly until the MS9400 receives a ‘Stop’ command from
the remote control.

To play a different Test File:

The user may wish to view other Test File(s) present on the MS9400:

1. Press the

button on the remote control (having first, pressed the or button).

The on-screen menu appears with a list of the Test Files pre-loaded in the Clips folder on the MS9400:

2. Use the joystick to navigate to the desired file. Press