System compatibility, Fiber cable transmission modes, Features – Extron Electronics FOX II T_R DP User Guide User Manual
Page 9
FOX II DP Transmitter and Receiver • Introduction
3
System Compatibility
The FOX II T DP transmitter is compatible with all Extron FOX II receivers
only.
The FOX II R DP receiver is compatible with all FOX II transmitters
and with existing
FOX 500, FOXBOX, and PowerCage FOX DVI, VGA and HDMI transmitters:
•
DVI Plus models: Resolutions up to 1920x1200 @ 60 Hz, with embedded audio and
analog audio support
•
Non plus models: Resolutions up to 1600x1200 @ 60 Hz, with analog audio support.
Embedded audio is not supported.
NOTES:
•
The receiver video output is HDCP-compliant when the transmitter input is from an
HDCP-compliant source and two fiber cables are used.
•
The FOX II receiver is
not compatible with the FOX AV, PowerCage FOX AV,
FOX 3G HD-SDI, PowerCage FOX 3G HD-SDI, and FOX 3G DVC models.
Fiber Cable Transmission Modes
The transmitter and receiver are further categorized by the type of fiber optic cable,
multimode or singlemode, which define the effective range of transmission:
Multimode — Long distance, up to 2 km (6,560 feet) (depending on the fiber cable)
•
FOX II T DP MM
•
FOX II R DP MM
Singlemode — Very long distance, up to 30 km (18.75 miles)
•
FOX II T DP SM
•
FOX II R DP SM
NOTE: The multimode and singlemode units are physically and functionally identical,
with the exception of the effective range of transmission. In this manual, any reference
applies to either transmission mode unless otherwise specified.