Extron Electronics FOX II T_R DP User Guide - Manual (Page 25)

FOX II DP Transmitter and Receiver • Remote Control 19
Unit-initiated Messages
When a local event, such as an equipment power-up, occurs, the unit responds by sending
a message to the host. The unit-initiated messages are listed below:
(c) Copyright 20 nn, Extron Electronics FOX II T DP , V x.xx, 60- nnnn - xx]]
- or -
(
c) Copyright 20 nn, Extron Electronics FOX II R DP , V x.xx, 60- nnnn - xx]]
The connected unit issues the appropriate copyright message (above) when it first
powers on.
V x.xx is the firmware version number; 60- nnnn - xx is the part number of the
connected unit.
Reconfig ]
The unit sends the Reconfig message whenever the video input signal to the transmitter is
changed.
1Lnk n• 2Lnk n• Vid n• Aud n• XX • Tx ]
- or -
1Lnk n• 2Lnk n• Vid n• Aud n• XX • Rx ]
The unit sends the status message whenever a change in the fiber link and video
connection occurs. n is the connection status, where
0 = link or input not detected and
1 = link or input detected. XX = either SM (singlemode) or MM (multimode).
EDidMdr nn]
The unit sends the EDID Minder change message whenever a change in the position of the
transmitter front panel DDC hex switch occurs.
Hplg2 ]
The unit sends the Hot plug message whenever the DisplayPort connector is either plugged
in or unplugged.
Error Responses
When the unit receives a valid SIS command, it executes the command and sends a
response to the host device. If the unit is unable to execute the command because the
command is invalid or it contains invalid parameters, the unit returns an error response to
the host. The error response codes are:
E10 - Invalid command
E13 - Invalid parameter
E14 - Invalid command for this configuration