Extron Electronics FOX II T_R DP User Guide - Manual (Page 30)

FOX II DP Transmitter and Receiver • Remote Control 24
Symbol Definitions for Receiver SIS Commands
] = CR/LF (carriage return/line feed)
} = Carriage return (no line feed)
| = Pipe (can be used interchangeably with the } character)
• = Space (hard) character
E = Escape key (hex 1B)
W = Can be used interchangeably with the E character
X# = Video and sync mute status 0 = off 2 = video and sync mute on
1 = video mute on
X$ = Audio gain adjustment range 00 to 10
X% = Audio level adjustment range –18 to +10 (in 1.0 dB steps)
X^ = Audio attenuation adjustment range 00 to 18
X& = Video delay 0 = 0 second
(0 plus six steps at 0.25 seconds per step) 1 = 0.25 second 3 = 0.75 second 5 = 1.25 second
2 = 0.5 second (default) 4 = 1.0 second 6 = 1.5 second
X( = Audio output 0 = DisplayPort and analog 1 = DisplayPort only 2 = Analog only
X1) = On and off status 0 = off 1 = on
X1@ = Receiver name
X1# = Link and input status 0 = link or input not detected 1 = link or input detected
X1$ = Input HDCP signal 0 = no source detected 2 = source detected but no HDCP present
1 = source detected with HDCP
X1% = Loop-through display 0 = no sink device connected 2 = sink device detected, but not HDCP compliant
1 = sink device detected and HDCP compliant
X1^ = Internal temperature nnnF•nnC
X1& = Transmission mode SM = singlemode MM = multimode
X1* = Firmware version v.vv
X1( = Frequency nnn.n
X2) = Optical module manufacturer Up to 16 alphanumeric characters
X2! = Tx or Rx power xx.x dBm
X2@ = Operating temp of module nnn.n
X2$ = Audio output level 0 = Consumer level (-10 dBV) 1 = Professional level (+4 dBu)
Command and Response Table for Receiver SIS Commands
Command SIS Command
(host to unit)
Response
(unit to host)
Additional description
Video and sync mutes
Mute output, video only 1B Vmt1 ] Mute the video output, display black video.
Mute output, video and sync 2B Vmt2 ] Mute the video and sync outputs.
Unmute output 0B Vmt0 ] Output video.
Show video mute status B X#] Video mute status is X# .
HDCP notification
Enable notification E N1HDCP} HdcpN1]
Disable notification E N0HDCP} HdcpN0]
View notification status E NHDCP} X1)]
Video shutdown delay
NOTES:
• The Set Video Delay command delays the digital video to help monitors sync correctly during an input rate change.
• Only video is delayed; embedded audio is not delayed.
Set delay 3* X& # Dly X&] Delay video by an interval of X& .
Example: 3*3# Dly3 ] Delay video by an interval of 0.75 seconds
(3 x 0.25 seconds).
View delay 3# X&]