Extron Electronics DSC 301 HD User Guide - Manual (Page 13)

Operation
This section of the manual discusses the operation of a DSC 301 HD device, and is
divided into the following sections:
•
Front Panel Overview
•
The DSC 301 HD Menu System — Configuration and Adjustments
•
Front Panel Lockout (Executive Modes)
Front Panel Overview
ADJUST
DSC 301 HD
CONFIG
1 3 2 HDCP
MENU ENTER
INPUT
OUTPUT
Extron
ADJUST
DSC 301 HD
CONFIG
1 3 2 HDCP
MENU ENTER
INPUT
OUTPUT
Extron
4
2 3 6 5
1
Figure 2. DSC 301 HD Front Panel Features
a
Status LED (power and signal) — This LED lights amber when power is present but
no signal, and green when power and signal are both present.
b
Front Panel mini USB configuration port — Connect a control system or computer
to this mini USB port for device configuration, control, and firmware upgrades.
c
Input selection buttons and LEDs (1-3) —
Input LEDs — The LED of the selected input lights when the button is pressed.
Input 1 (composite video input button) — Input 1 selects the composite video
input.
Input 2 (configurable input button) — Input 2 selects the RGB (RGBHV, RGBS) or
YUV (YUV-HD, YUVp, YUVi) input.
Input 3 (HDMI/DVI button) — Input 3 selects the HDMI or DVI input signal.
d
HDCP content LEDs — These LEDs indicate HDCP status for inputs and output;
• Light green when the input or connected display is HDCP encrypted.
• Remain unlit when the current input or HDMI output is not HDCP encrypted.
• Flash amber when the video output has been disabled (such as when in sync mute
or screen saver mode).
e
Menu Navigation buttons (Menu and Enter) —
Menu — Press this button to access and move through the OSD menu system.
Enter — Press this button to step through the OSD submenus.
See the “ The DSC 301 HD OSD Menu System — Configuration and
Adjustments ” section on the next page.
g
Adjustment knobs (horizontal [and vertical {) — When using the menu system,
rotate either of these two knobs to scroll through the menu options and to make any
adjustments.
DSC 301 HD • Operation 7