Extron Electronics CS 120P User Guide - Manual (Page 9)

Installation
This section provides instructions for installing the CS 26T speakers and the CS 120P
enclosure. Topics include:
• Installation Considerations
• Installation Configurations
• Installing the CS 1226T — Single Installer
• Installing the CS 120P in a Suspended Ceiling — Division of Labor
• Installing the CS 26T in a Suspended Ceiling — Division of Labor
• Installing CS 120P in a Hard Ceiling
Installation Considerations
WARNING: Risk of severe bodily injury from falling or sharp equipment.
Installation and service must be performed by authorized personnel only.
• All wiring and electrical connections must conform to all applicable building codes and
local ordinances.
• Installation in a plenum-rated environment requires plenum rated cable or conduit.
• If using secondary support cables, the installer provides the cables.
Installation Configurations
The CS 26T can be configured in the following ways:
• Open-back: For configurations in which the CS 120P is not used, use the C-ring
accessory, available at
www.extron.com . The C-ring spreads out the clamping force of
the dog-legs when used in drop ceilings and gypsum ceilings.
• Using the CS 120P: When used with the CS 120P, the CS 26T can be placed in
plenum environments. This is the only configuration that is UL 2043 rated.
NOTE: The CS 120P can be ordered separately or as part of the CS 1226T kit.
For hard ceiling installations, see Installing the CS 120P in a Hard Ceiling on
page 26.
CS 26T and CS 120P User Guide • Installation 3