Extron Electronics CS 120P User Guide - Manual (Page 31)

9. Set the rotary tap selector switch — Use a small screwdriver to set the tap selector
switch to the appropriate setting.
ATTENTION: When setting the taps for a distributed (high impedance) system,
do not tap the system above the rated power of the amplifier. When connecting
multiple speakers in 8-ohm mode, be sure that the combined rated impedance
does
not equal a value less than the minimum rated impedance of the amplifier.
Adjust the Tap Selector
8W
16W
100
V
70
V 4W
2W
4W
2W
1W
8W
8Ω
8Ω
16W
Figure 42. Adjusting the Rotary Tap Selector
10. Install the grille — Position the outer perimeter of the grille into the groove of the
speaker baffle. Six magnets pull the grille securely into place.
Speaker Grille
Figure 43. Installing the Speaker Grille
NOTE: Grille hooks are provided for removal of the grille after installation.
CS 26T and CS 120P User Guide • Installation 25