YSI pHotoFlex STD Colorimeter - Manual (Page 59)

pHotoFlex
®
STD Operation
59 ba76122e01 02/2013
The individual data sections of the command line are separated by
commas. The dot "." has to be used as a decimal separator within a
data section.
If there is already a program stored under the selected number, the pro-
gramming is canceled. If you wish to store the program under the se-
lected number, you have to erase the program stored under the
number first.
After a successful transmission, the terminal program writes "!>".
After a failed transmission, the terminal program writes "!>".
Erasing user-defined
programs
To erase user-defined programs, enter a command line according to
the following scheme in the terminal program:
After a successful transmission, the requested data is displayed on the
terminal.
After a failed transmission, the terminal program writes "!>".
Reading out user-
defined programs
To read out user-defined programs, enter a command line according to
the following scheme in the terminal program:
5 Enter the command line.
6 Finish the command line with Enter.
The data is transmitted to the pHotoFlex
®
STD.
Erase all user-defined
programs Erase one user-
defined program
Command line U.520 U.521#1,Program No
Example U.520 U.521#1,900
7 Enter the command line.
8 Finish the command line with Enter.
The data is transmitted to the pHotoFlex
®
STD.
The requested data is displayed on the terminal as the result.
Read out all user-
defined programs Read out one user-
defined program
Command line U.510 U.511#1,Program No
Example U.510 U.511#1,900
9 Enter the command line.