Armasight NAMPVS1401F9DA1 PVS14 FLAG MG Multi-Purpose Night Vision Monocular - Manual (Page 48)

48
While donning and adjusting the headmount, it is possible for a strap to slip out of a slide fastener.
Perform the following procedure to adjust the strap and sliding bar buckle.
(1) Thread the strap from the inside of the buckle over the moveable sliding bar (see Figure 4-2.). Thread
the strap back through the buckle but this time under the moveable sliding bar and over the serrated
part of the buckle.
(2) Pull the strap through the buckle and tighten as necessary.
(3) Repeat steps 1 and 2 for other straps and buckles that may have come undone.
4.3.3. NECK CORD MAINTENANCE
The neck cord (Figure 2-1) may be broken, frayed, or loose at one or both ends.
If loose, re-tie cord. If broken or severely frayed, install new cord as follows:
(1) Insert ends through monocular holes from the rear.
(2) Thread right cord end through hole in objective lens cap.
(3) Tie a knot in each end.
4.4 SERVICE/PACKING AND UNPACKING
4.4.1 RETURN INSTRUCTIONS
For service, repair or replacements, please email [email protected].
To assist the Service Representative (SR) with determining if the item is repairable, please provide the
following information:
(1) Serial Number of the defective item.
(2) Thorough description of the malfunction, defect or damage.
(3) An explanation of how the malfunction, defect or damage occurred, if known.
If the SR determines that the item is under warranty or should be returned for repair, a Return Material
Authorization number (RMA#) will be provided.
When returning the PVS-14/6015 for service or repair, the following procedures should be followed to
prevent any additional damage:
(1) Verify that the PVS-14 is free of all contaminants such as dirt or any other foreign material.
(2) Remove the battery.
(3) Place the cap over the lens.
(4) Place the PVS-14/6015 in the hard shipping/ storage case or soft carrying case (if available). If the
hard shipping/ storage case is not available, individually package each PVS-14 unit being returned in
a suitable container.
Place the PVS-14/6015 and a copy of the test report or detailed description of the failure in a suitable
packing/ shipping container. Mark the package with the RMA#. Ship the items using the fastest, most
easily traceable, prepaid method to Armasight Inc., 815 Dubuque Avenue, South San Francisco, CA
94080, USA.