Asus K8N4-E DELUXE User Manual
Page 83

A S U S K 8 N 4 - E D e l u x e
A S U S K 8 N 4 - E D e l u x e
A S U S K 8 N 4 - E D e l u x e
A S U S K 8 N 4 - E D e l u x e
A S U S K 8 N 4 - E D e l u x e
4 - 1 7
4 - 1 7
4 - 1 7
4 - 1 7
4 - 1 7
Extended IDE Drive
[Auto]
Access Mode
[Auto]
Capacity
0 MB
Cylinder
0
Head
0
Precomp
0
Landing Zone
0
Sector
0
Select Menu
Item Specific Help
Selects the type of
fixed disk connected
to the system.
First SATA Master
4.3.8
4.3.8
4.3.8
4.3.8
4.3.8
First, Second, Third, and Fourth SATA Master
First, Second, Third, and Fourth SATA Master
First, Second, Third, and Fourth SATA Master
First, Second, Third, and Fourth SATA Master
First, Second, Third, and Fourth SATA Master
Extended IDE Drive [Auto]
Extended IDE Drive [Auto]
Extended IDE Drive [Auto]
Extended IDE Drive [Auto]
Extended IDE Drive [Auto]
Select [Auto] to automatically detect a SATA hard disk drive. If automatic
detection is successful, Setup automatically fills in the correct values for
the remaining fields on this sub-menu. Configuration options: [None]
[Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Allows the user to select the sector addressing mode. Refer to the
previous page for detailed descriptions of the different modes.
Configuration options: [Large] [Auto]
Capacity
Capacity
Capacity
Capacity
Capacity
Displays the auto-detected hard disk capacity. This item is not
configurable.
Cylinder
Cylinder
Cylinder
Cylinder
Cylinder
Shows the number of the hard disk cylinders. This item is not configurable.
After entering the IDE hard disk drive information into BIOS, use a disk
utility, such as FDISK, to partition and format new IDE hard disk drives.
This is necessary so that you can write or read data from the hard disk.
Make sure to set the partition of the Primary IDE hard disk drives to
active.