Asus K8N4-E DELUXE - Manual (Page 82)

4 - 1 6 4 - 1 6 4 - 1 6 4 - 1 6 4 - 1 6 C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p
Access Mode [Auto] Access Mode [Auto] Access Mode [Auto] Access Mode [Auto] Access Mode [Auto]
This item allows the user to select the sector addressing mode. CHS
(cylinder, head, sector) mode supports 528 MB hard disks. LBA (logical
block addressing) mode supports hard disks up to 128 GB in size. Large
mode (also called extended CHS mode) supports hard disks above 528 MB
in size, but does not support LBA mode. Configuration options: [CHS]
[LBA] [Large] [Auto]
Capacity Capacity Capacity Capacity Capacity
Displays the auto-detected hard disk capacity. This item is not
configurable.
Cylinder Cylinder Cylinder Cylinder Cylinder
Shows the number of the hard disk cylinders. This item is not configurable.
H e a d H e a d H e a d H e a d H e a d
Shows the number of the hard disk read/write heads. This item is not
configurable.
Sector Sector Sector Sector Sector
Shows the number of sectors per track. This item is not configurable.
Transfer Mode Transfer Mode Transfer Mode Transfer Mode Transfer Mode
Shows the Transfer mode. This item is not configurable.
Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto] Primary IDE Master [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, Setup automatically fills in the correct values for
the remaining fields on this sub-menu. If automatic detection fails, this may
be because the hard disk drive is too old or too new. If the hard disk was
already formatted on an older system, Setup may detect incorrect
parameters. In these cases, select [Manual] to manually enter the IDE hard
disk drive parameters. Refer to the next section for details. Configuration
options: [None] [Auto] [Manual]
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.