Asus M2Ne - Manual (Page 20)

ASUS Motherboard installation guide
1
English
To connect the front panel cables:
•
RESET (Reset Switch)
• PLED (Power LED)
• PWRSW (Power Switch)
• IDE_LED (IDE Hard Disk Active LED)
• SPEAKER (Speaker Connector)
1.8 Front panel cables
M2N-X
F_PANEL
PLED- PWR PLED+
Ground
GND
Reset
IDELED+ IDELED-
HD LED RESET
PWR LED PWR BTN
P5B-E
®
* Requires an ATX power supply.
PANEL
PLED-
PW
R
+5V Speaker
Ground
RESET
Ground
Reset
Ground Ground
PWRSW
PLED+
IDE_LED
-
IDE_LED
+
IDE_LED
PLED SPEAKER
PIN1
PIN1
• The front panel cables of your chassis may differ with models or designs.
Connect these connectors to the motherboard according to the label.
• If the LEDs do not light up and the pin loction is correct, you might misplace
the ground pins with the signal pins. Usually the white wire stands for the
ground pins and the color‑coded wire for the signal pins.
• The SPEAKER, RESET and PWRSW front panel cables have no specific
orientation, while IDE_LED and PLED cables do. Connect the the cable
PIN1 to the connector PIN1 on the motherboard.
• The front panel connector varies with your motherboard model, refer to the
user guide for more information.
20- pin front panel connector
10-1 pin front panel connector