GE Industrial Solutions HE300GEN150 - Manual (Page 14)

MAN0373-01 13 APR 2000 PAGE 15
CH.3
CHAPTER 3: OPTION CARD CONFIGURATION (USING AF-300 KEYPAD)
3.1 Keypad Functionality
The keypad functions and operations are covered in the drive manufacturer documentation. This
document is concerned only with describing the keypad functions that are used to configure the option
card and effect the option card operation.
3.2 Option Card Configuration Parameters
The following table lists and describes the parameter settings used to configure the Option Card
parameters. As described previously, Genius devices have the capacity to broadcast 128 bytes (64
words) of global data and receive 128 bytes (64 words) of directed data. The Option Card is limited to 24
bytes (12 words) of global data and 20 bytes (10 words) of directed data. The parameter values can be
changed using the instructions found in the drive manufacturer’s documentation.
Table 3.1 – Parameter Settings
Option
Card
Parameter
Description Valid Input
Values
Default Value (o31 = 255)
o30 Bus Address 0-31 (1-30
typical)
1
o31 Baud Rate
•
0 = 153.6K EXT
•
1 = 153.6K STD
•
2 = 76.8K
•
3 = 38.4K
•
255 = Reset parameters to
default
0-3
255
1 = 153.6K standard
o32 Global Data Length 0 - 12 7
o33 Directed Data Length 0 - 10 4
o34 User Defined Broadcast Data 1 1-254
0;255*
M14 Operating State
o35 User Defined Broadcast Data 2 1-254
0;255*
M06 Actual Frequency
o36 User Defined Broadcast Data 3 1-254
0;255*
M11 Output Current
o37 User Defined Broadcast Data 4 1-254
0;255*
M10 Motor Output
o38 User Defined Broadcast Data 5 1-254
0;255*
M16 Fault Memory 0
o39 User Defined Broadcast Data 6 1-254
0;255*
M07 Actual Torque
o40 User Defined Broadcast Data 7 1-254
0;255*
M01 Frequency Command
o41 User Defined Broadcast Data 8 1-254
0;255*
255
o42 User Defined Broadcast Data 9 1-254
0;255*
255
o43 User Defined Broadcast Data 10 1-254
0;255*
255