GE Industrial Solutions MicroVersaTrip Plus and MicroVersaTrip PM AK-25 and AKU-25 - Manual (Page 4)

4
SECTION 1 INSTALLING THE
WIRE HARNESS ASSEMBLY
(CONTINUED)
Wire Harness Connector Assembly and
Installation (Continued)
Step 3.
Slide the adapter bracket and connector assembly
over the guide pins of the programmer bracket.
Press the two (2) steel push nuts provided onto
the guide pins using a nut driver until the
assembly is held firmly against the programmer
bracket (Fig. 1d).
Step 4.
While holding the adapter bracket and connector
assembly firmly in place against the programmer
bracket, bend the two (2) locking tabs on the
programmer bracket into the mating notches on
the adapter bracket using a screwdriver (Fig. 1e).
Step 5.
Refer to the installation instructions provided with
the MicroVersaTrip Plus
 or MicroVersaTrip PM 
conversion kit to complete the wire harness
installation process.
Fig. 1d. Installing Push Nuts
Fig. 1e. Programmer Bracket Locking Tabs