GE Industrial Solutions MicroVersaTrip Plus and MicroVersaTrip PM AK-25 and AKU-25 - Manual

g
DEH-127 Supplementary Instructions
MicroVersaTrip
 
Plus and
MicroVersaTrip
 
PM
Conversion Kits
For Installation of MicroVersaTrip

Plus &
MicroVersaTrip

PM Programmer Trip Units or
Wire Harness Assemblies on Low Voltage
Power Circuit Breakers
SUPPLEMENTARY INSTRUCTIONS ONLY
This publication must be used in conjunction with the specific MicroVersaTrip  Plus or PM
Conversion Kit installation instructions for your type of Low Voltage Power Circuit Breaker.
INTRODUCTION
GE Conversion Kits are designed to upgrade existing Low Voltage Power Circuit Breakers, rather than
replacing the entire breaker. The Conversion Kits contain enhanced solid-state MicroVersaTrip
 Plus or
MicroVersaTrip  PM Trip Units, representing the latest technological advancement in GE trip systems.
MicroVersaTrip  Plus and MicroVersaTrip  PM Conversion Kits are designed and breaker tested to
conform to ANSI Standard C37.59, allowing the retrofitter to properly install and acceptance test the
breaker.
This supplementary publication covers specific instructions for the installation of MicroVersaTrip  Plus
and MicroVersaTrip  PM Conversion Kit programmer trip units or wire harness assemblies on Low
Voltage Power Circuit Breakers. The information included in this manual may be similar to the
installation instructions provided with your MicroVersaTrip
 Plus or MicroVersaTrip  PM Conversion Kit
but this supplementary publication should be referenced as the latest instructions available for the
installation of the programmer trip unit or wire harness assembly on Low Voltage Power Circuit
Breakers.