GE Industrial Solutions ASTAT-SD Solid-State Reduced Voltage Starter - Manual (Page 16)

ASTAT-SD ™ Solid-State Reduced Voltage Starters
Chapter 2. Installation & Start-up
12
2-9 Start-up
Make sure equipment wiring corresponds to one of the recommended wiring diagrams
or equivalent.
Make sure the control wiring corresponds to the control voltage used.
Set starting parameters according to your application.
Set stopping parameters according to your application.
Set the rest of the parameters as needed.
Start motor and make sure that operation is correct.
A1
110/120V ac
A2 B1 B2 A1
220/240V ac
A2 B1 B2
40 20 30
10 50
0.5 60
RAMP(s)
ILT/TORQUE
HD/SD
1 0
KICK START
SOFT STOP
EOR/RUN
OVERRIDE
ILT/TORQUE
HD/SD
1 0
KICK START
SOFT STOP
EOR/RUN
OVERRIDE
Voltage ramp or current limit Acceleration ramp time Kick start feature
50
4/60 3/40
70 30
2/15 5/80
ILT/TORQUE
ILT/TORQUE
HD/SD
1 0
KICK START
SOFT STOP
EOR/RUN
OVERRIDE
ILT/TORQUE
HD/SD
1 0
KICK START
SOFT STOP
EOR/RUN
OVERRIDE
Select relay output (contact 11-14) as
RUN or End of Ramp (at speed) relay
ILT/TORQUE
HD/SD
1 0
KICK START
SOFT STOP
EOR/RUN
OVERRIDE
Select full voltage or energy
saving at steady state