Theatre Solution Jury Base Seating - Manual (Page 70)

Jury Base Seating Installation Instructions 69
Jury Base Seating Installation Instructions
(This section pertains to the Teatro Jury Base Seating model.)
(Note: See Exploded Assembly [Figure 27] and Floor Mounting Details [Figure 28] on following pages.)
1. Use approved floor plan to establish hole locations for the bases.
2. When mounting chairs over carpet, punch two 5/8" diameter holes in carpet to match holes in the base. Bolt the
base (A) to the floor as per the appropriate anchoring method. Use 1/4" flat head machine bolt or wood screws
and countersink lock washers. Hand-tighten bolts to allow for some slight movement. (See figure 28.)
3. Insert the column (B) into the base (A) and slide the two-piece column shroud (C) over the column.
4. Attach the mechanism (D) to the frame assembly (E) using four 1/4-20 x 1” pan head machine screws, four flat
washers, four split lock washers, and four hex head nuts. See Bottom View, Figure 27 for details.
5. Gently place the frame assembly (E) with attached mechanism over the column (B), insuring proper directional
orientation. After confirming correct alignment, apply a load to center of the frame in order to assure full
engagement of tapered connections between mechanism, column, and base.
6. Attach the back (J) to the frame assembly (E) using two 1/4-20 x 3/4” flat head machine screws and two 3/8-16 x
1-1/4” flat head machine screws, through the frame assembly and into the sides of the back.
7. Attach the seat (H) to the frame assembly (E) using four 1/4-20 x 1” pan head machine screws and split lock
washers, through the frame assembly, into the bottom of the seat.
8. Attach right armrest (F) and left armrest (G) to the frame assembly (E) using four #8 x 5/8” pan head sheet metal
screws for each armrest.
9. Tighten all floor attachments securely. Adjust the column shroud (C) to hide the steel cylinder (B).