Jury base seating specifications – Theatre Solution Jury Base Seating User Manual

Page 58

Jury Base Seating Specifications

Jury Base Seating Specifications

(This section pertains to the Aeron Jury Base Seating model.)

PART 2 – PRODUCTS

2.1 SEATING

A. Provide from Theatre Solutions, Inc., 121 Park Avenue, Quakertown, PA 18951, the Aeron

Jury Base

Seating as follows:

1. Basic floor-mounted Jury Base Aeron chair.

Model noted is based on the Theatre Solutions, Inc. Aeron Jury Base Seating with the intent of establishing
the high level of quality required for the project. Other brands submitted for approval will be given
consideration provided that a full seating mock-up, along with a complete list of specification discrepancies
between the proposed substitution and the product specified is received at least 10 working days prior to
the bid date.

1. By offering a quote for this project, the bidder assumes full responsibility for complying with the

specifications for this project and shall be totally responsible for any expenses incurred if the
product quoted does not comply with the specifications.

Failure to comply with the warranty described in Part 4 of these specifications will be cause for
disqualification.

2.2 MATERIALS

A. Seating material shall be Herman Miller Pellicle

with the color and pattern to be selected from the

standard offering.

2.3 FABRICATION,

GENERAL

A. Fabricate the seating for maximum comfort using materials that are carefully selected to be free from

defects, objectionable projections, or irregularities. Smooth round corners and edges to present the least
possible snagging and pinching hazards.

2.4 MOUNTING

A. The floor base shall be cast aluminum with a durable powder coated finish. The base shall include four

countersunk holes equally spaced around the perimeter of the base for mounting to the floor with 1/4” flat
head screws, providing a flush, unobtrusive appearance.

2.5 CHAIRS

A. Chair shall be Herman Miller model Aeron

Chairs shall include a separate seat and back and shall consist of a durable, breathable Pellicle material
stretched within a carrier ring and fitted into an outer frame. The Pellicle material shall be a woven blend of
spandex and colored polyester yarn with Hytrel elastomeric polyester. The carrier ring shall be a glass-
filled elastomeric copolymer molded around the perimeter of the Pellicle material. The outer frame shall be
injection-molded, glass reinforced thermoplastic polyester. The ring and frame shall be secured together
with screws.

C. Chairs shall include the Kinemat

tilt mechanism.

D. The chair shall be equipped with a swivel and return cylinder.