Theatre Solution Jury Base Seating - Manual (Page 64)

Jury Base Seating Specifications 63
Jury Base Seating Specifications
(This section pertains to the Teatro Jury Base Seating model.)
PART 3 – OPTIONS
3.1 BACK WITH OUTER WOOD PANEL, PLYWOOD EDGES
A. Back Construction: Solid back construction comprised of a curved plywood veneer outer panel fastened
solidly and without voids to an inner structural plywood panel. The outer panel shall be 3/4” thick, faced
one side with Grade A veneer centered across the width of the panel, and exposed plywood laminations
along all edges. The inner panel shall be 3/8” thick. Both shall be electronically glued hardwood plywood
and shall be fastened together with bayonet hanging brackets at the top and two #8 x 3/4” trim head screws
at the bottom, resulting in a rigid connection with no visible fasteners on the outer wood panel. The veneer
face and edges of the outer panel shall be stained to match the architect’s sample. The padding material
shall be 1-3/4” thick polyurethane foam, 2-3/4” thick in the lumbar region, shall be glued to the inner panel,
and shall conform to the California Bureau of Home Furnishings Technical Bulletin 117. The back
assembly shall be attached to the frame assembly using (2) 1/4-20 x 3/4” flat head machine screws and (2)
3/8-16 x 1-1/4” flat head machine screws.
3.2 BACK WITH OUTER WOOD PANEL, HARDWOOD EDGES
A. Back Construction: Solid back construction comprised of a curved plywood veneer outer panel fastened
solidly and without voids to an inner structural plywood panel. The outer panel shall be 3/4” thick, faced
one side with Grade A veneer centered across the width of the panel and 1/8” thick hardwood matching the
species of the veneer along the top and vertical edges. The inner panel shall be 3/8” thick. Both shall be
electronically glued hardwood plywood and shall be fastened together with bayonet hanging brackets at the
top and two #8 x 3/4” trim head screws at the bottom, resulting in a rigid connection with no visible
fasteners on the outer wood panel. The veneer face and edges of the outer panel shall be stained to
match the architect’s sample. The padding material shall be 1-3/4” thick polyurethane foam, 2-3/4” thick in
the lumbar region, shall be glued to the inner panel, and shall conform to the California Bureau of Home
Furnishings Technical Bulletin 117. The back assembly shall be attached to the frame assembly using (2)
1/4-20 x 3/4” flat head machine screws and (2) 3/8-16 x 1-1/4” flat head machine screws.
3.3 INSET UPHOLSTERY, BACK
A. Back upholstery shall be inset to expose the veneer face on the inside of the outer back panel. The veneer
on the inside face on the back panel shall match the veneer species on the outside face and be stained to
match.
3.4 END PANEL
A. Provide manufacturer’s standard end panel for both sides of each chair. The configuration of the panel
shall follow the angle of the frame and back at the rear, and shall be vertical at the front end. The panel
shall be constructed of 3/4” thick plywood with veneer on both sides and 1/8” thick hardwood on the vertical
edges. The end panel shall be stained to match the outer wood seat, back, and armrests.
3.5 TILT MECHANISM
A. Chair shall include a tilt mechanism with a tilt tension adjustment.
3.6 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133