Theatre Solution Jury Base Seating User Manual

Page 22

Lecture Seating Specifications

2.6 CHAIRS

A. Chair shall be Herman Miller model Aeron

Chairs shall include a separate seat and back and shall consist of a durable, breathable Pellicle material
stretched within a carrier ring and fitted into an outer frame. The Pellicle material shall be a woven blend of
spandex and colored polyester yarn with Hytrel elastomeric polyester. The carrier ring shall be a glass-
filled elastomeric copolymer molded around the perimeter of the Pellicle material. The outer frame shall be
injection-molded, glass reinforced thermoplastic polyester. The ring and frame shall be secured together
with screws.

C. Chairs shall include the Kinemat

tilt mechanism.

2.7 WORKSURFACES

A. Tables are to be a 3-ply warp resistant construction with a core of 1-1/8” thick 45-50 lb. density particle

board, a 0.020” Kraft backer sheet, and a face material of 0.030” high-pressure laminate.

B. The edge detail is to be (select one edge detail from the list below)

3mm PVC – 3mm x 1-1/4” PVC on all table edges that would be exposed after installation, with a 1/8”
radius on the top and bottom edges. The table corners are square with an overlap joint.

3mm Hardwood – 3mm x 1-1/4” hardwood on all table edges that would be exposed after installation,
with 1/8” radius on the top and bottom edges, finished to match the architect’s sample. The table
corners are square with an overlap joint.

Bevel – 3/4” x 1-1/4” solid hardwood on all table edges that would be exposed after installation, with a
3/8” x 45 degree bevel detail along the top edge, finished to match the architect’s sample. The table
corners are mitered.

Chamfer – 3/4” x 1-1/4” solid hardwood on all table edges that would be exposed after installation, with
a 1/4” radius on the top edge blending into a 60 degree backcut chamfer edge detail, finished to match
the architect’s sample. The table corners are mitered.

Bullnose – 3/4” x 1-1/4” solid hardwood on all table edges that would be exposed after installation, with
a full 5/8” radius bullnose edge detail, finished to match the architect’s sample. The table corners are
mitered.