Theatre Solution Jury Base Seating - Manual (Page 65)

64 Specifications Jury Base Seating
Jury Base Seating Specifications
(This section pertains to all models of Jury Base Seating.)
PART 4 – WARRANTY
4.1 The Jury Base seating manufacturer must provide a Warranty to the original purchaser of the seating as follows:
A. The manufacturer shall warrant the product for five (5) years from the date of shipment. This warranty
applies to the original purchaser and is non-transferable. The manufacturer will provide parts and labor to
replace defective parts.
B. This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by
modifications to the product by anyone other than an authorized seating manufacturer technician will void
this warranty. This warranty does not apply to fabrics or products not installed by authorized seating
manufacturer technicians.
PART 5 - EXECUTION
5.1 EXAMINATION
A. Examine site conditions, with installer present, for compliance with requirements for construction tolerances
as they affect anchors and fasteners, and location of junction boxes.
B. Do not proceed until unsatisfactory conditions have been corrected.
5.2 GENERAL
A. Comply with seating manufacturer’s printed installation instructions applicable to products.
B. Locate seating in locations indicated on approved shop drawings, with required clearances.
C. Install standards in locations conforming to seating layout, with each chair base attached to substrate by no
less than four anchoring devices of size and type required to insure that chairs are stable under conditions
of actual use.
D. Install chairs using manufacturer’s recommended hardware and fasteners. Insure that chairs in curved
rows are installed on proper radius and are oriented toward the center point of the radius. Verify that
moving components operate smoothly and quietly.
5.3 ADJUSTING
A. Adjust as required to assure that the seats in each row are aligned when in the unoccupied position.
B. Touch-up minor abrasions and imperfections in painted finishes with coating that matches factory-applied
finish.
C. Replace any upholstery that has been damaged during installation.
END OF SPECIFICATION
® Herman Miller, Aeron, Equa 2, Pellicle, and Kinemat are among the registered trademarks of Herman Miller, Inc.