Theatre Solution Jury Base Seating - Manual (Page 61)

60 Specifications Jury Base Seating
Jury Base Seating Specifications
(This section pertains to the Acclaim Jury Base Seating model.)
PART 3 – OPTIONS
3.1 BACK WITH OUTER WOOD PANEL, PLYWOOD EDGES
A. Back Construction: Solid back construction comprised of a curved plywood veneer outer panel fastened
solidly and without voids to an inner structural plywood panel. The outer panel shall be 3/4” thick, faced
one side with Grade A veneer centered across the width of the panel, and exposed plywood laminations
along all edges. The inner panel shall be 3/8” thick. Both shall be electronically glued hardwood plywood
and shall be fastened together with bayonet hanging brackets at the top and two #8 x 3/4” trim head screws
at the bottom, resulting in a rigid connection with no visible fasteners on the outer wood panel. The veneer
face and edges of the outer panel shall be stained to match the architect’s sample. The padding material
shall be 1-3/4” thick polyurethane foam, 2-3/4” thick in the lumbar region, shall be glued to the inner panel,
and shall conform to the California Bureau of Home Furnishings Technical Bulletin 117. The back
assembly shall be attached to the frame assembly using (4) 1/4-20 x 1/2” pan head machine screws with
external tooth lock washers.
3.2 UPHOLSTERED END PANEL
A. Provide manufacturer’s standard upholstered end panel for both sides of each chair. The configuration of
the panel shall conform to the shape of the end standard frame and shall present fabric surfaces to both
the inside and outside of the chair. The end panel assembly shall consist of one inside and one outside
panel that are machined of 1/2” thick fiberboard and have all edges eased to insure suitability for
upholstery. The outside panel is to contain four 10-24 threaded steel inserts to facilitate assembly to inner
panel with four 10-24 x 2” flat head machine screws.
3.3 VENEER END PANEL
A. Provide manufacturer’s standard veneer end panel for both sides of each chair. The configuration of the
panel shall conform to the shape of the end standard frame and shall present finished veneer surfaces to
both the inside and outside of the chair. Veneer species and finish to match hardwood armrests. The end
panel assembly shall consist of one inside panel machined of 1/2” thick birch plywood and one outside
panel machined of 3/4” thick birch plywood. The outside panel is to contain four 10-24 threaded steel
inserts to facilitate assembly to the inner panel with four 10-24 x 2” flat head machine screws.
3.4 TILT MECHANISM
A. Chair shall include a tilt mechanism with a tilt tension adjustment.
3.5 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133